PicoAAB é o mais pequeno mosfet de 3ª geração com Active Brake. Pode ser instalado em qualquer AEG, mesmo nas mais pequenas.
A instalação é simples, mas implica uma ligação ao switch de gatilho
Do you want to achieve a higher rate of fire and faster trigger response? Are you planning a power upgrade of your rifle? In that case, you need a MOSFET.
Do you care about realism? Would you like to increase the life of the gearbox? Does your rifle have such a high rate of fire that you are not able to make a single shot? The Active Brake sorts things out. In SEMI Mode, the brake does not allow for compressing a piston after a shot. The piston will stop in the front position which eliminates unnecessary stresses, increasing the service life of the gearbox and its parts. This is important, especially with an AEG power upgrade. After releasing the trigger, the rifle immediately stops firing. So, you gain more realism and, additionally, you do not waste your precious ammunition.
We know how important reliability is on the battlefield. That’s why the unit has thermal protection. In tandem with a time-lag fuse, it fully protects your AEG installation.
This provides full compatibility with the micro-switches. It ensures full resistance to contact bounce (vibration). You gain a bigger ROF, a faster trigger response and your MOSFET is less prone to overheating.
3RD GENERATION MOSFET
The advent of modern transistors and microcontroller has enabled us to create the smallest and most reliable AEG Controller on the market.
Included in the kit:
- Single signal wire for trigger contacts
- Double signal wire for trigger contacts
- Male terminal [2,8x0,8mm] with red heatshrink tube (for battery positive wire)
- Male terminal [2,8x0,5mm] with black heatshrink tube (for motor negative wire)
- Male terminal [2,8x0,5mm] with red heatshrink tube (for motor positive wire)
- Female terminal [2,8x0,5mm] with black thin heatshrink tube (for battery negative wire)